Kia Stinger: Smart cruise control with stop & go system / Vehicle to vehicle distance setting (Smart cruise control system)

Kia Stinger CK 2018-2024 Owners Manual / Driving your vehicle / Smart cruise control with stop & go system / Vehicle to vehicle distance setting (Smart cruise control system)

To set vehicle to vehicle distance

This function allows you to program the vehicle to maintain relative distance to the vehicle ahead without depressing the accelerator pedal or brake pedal.

The vehicle to vehicle distance will automatically activate when the smart cruise control system is on.

Select the appropriate distance according to road conditions and vehicle speed.

Each time the button is pressed, the vehicle to vehicle distance changes as follows:

For example, if you drive at 90 km/h (56 mph), the distance is maintained as follows;

Distance 4 - approximately 52.5 m (172 feet)
Distance 3 - approximately 40 m (130 feet)
Distance 2 - approximately 32.5 m (106 feet)
Distance 1 - approximately 25 m (82 feet)

✽ NOTICE

The distance is set to the last set distance when the system is used for the first time after starting the engine.

Speed setting (Smart cruise control system)
To set Smart Cruise Control Speed 1. Press the CRUISE button, to turn the system on. The CRUISE indicator in the instrument cluster will illuminate. 2. Accelerate to the desired speed. 30 km ...

When the lane ahead is clear
The vehicle speed will maintain the set speed. When there is a vehicle ahead of you in your lane The vehicle will maintain the set speed, when the lane ahead is clear. The vehicle will slow ...

Other information:

Kia Stinger CK 2018-2024 Service Manual: Auto Defoging Actuator


Description and operation Description Installed on the windshield glass, the auto defogging sensor judges and sends signal to blow out wind for defogging if moisture occurs. The air conditioner control module receives a signal from the sensor and restrains moisture and eliminates d ...

Kia Stinger CK 2018-2024 Service Manual: Overhead Console Lamp


Repair procedures Inspection 1. Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch. Removal 1. Disconnect ...

Copyright © www.kstinger.com 2015-2024