Kia Stinger: Tires/Wheels / Wheel
Repair procedures
Hub nut tightening sequence |
Tighten the hub nuts as follows.
Tightening torque:
107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94.0 lb·ft)
|
When using an impact gun, final tightening torque should be checked using
a torque wrench.
|
Run out inspection
2. |
Measure the wheel run-out by using a dial indicator as shown below.
Run-out
|
Aluminum
|
Radial mm (in.)
|
Below 0.3 (0.0118)
|
Lateral mm (in.)
|
Below 0.3 (0.0118)
|
|
3. |
If measured value exceeds the standard value, replace the wheel.
|
Repair procedures
Tire Wear
•
Using tires and wheels other than the recommended sizes can c ...
Repair procedures
Front wheel alignment
When using a commercially available computerized wheel alignment equipment
...
Other information:
Specifications
Specification
Accelerator
Position
Output Voltage (V) [Vref = 5V]
APS1
APS2
C.T
0.7 - 0.8
0.33 - 0.43
W.O.T
3.99 - 4.23
1.94 - 2 ...
All tire pressures (including the spare) should be checked when the tires are
cold. “Cold Tires” means the vehicle has not been driven for at least three hours
or driven less than 1.6 km (one mile).
Recommended pressures must be maintained for the best ride, top vehicle handling,
and mini ...