Kia Stinger: ESP(Electronic Stability Program) System / Emergency Signal System
Description and operation
Introduction of quick
brake warning system (ESS)
In case of quick brake by driver, the brake lamp or turn signal is blinked to
warn against the vehicle at rear.

1. |
Basic function (Blinking the brake lamp/emergency lamp)
– |
Operation condition: In case of quick brake or operation of ABS
above in a certain speed
|
– |
Releasing condition: In case of stopping the quick brake or releasing
the ABS operation
|
|
2. |
Additional function (Blinking the turn signal)
– |
Operation condition: In case of quick brake in low speed
|
– |
Releasing condition: Releasing at the start of driving
|

|
System configuration

ESS Circuit diagram

Components and components location
Components Location
1. HECU module
2. Front wheel speed sensor (2WD)
3. Front wheel speed sensor (AWD)
4. Rear wheel sp ...
Components and components location
Components
1. FR
2. RL
3. RR
4. FL
5. MC2 (SEC)
6. MC1 (PRI)
7. Damper
8. ESP control module connector
...
Other information:
Description
On this mode, you can change setting of the doors, lamps, and so on.
WARNING
Do not adjust the User Setting while driving.You may lose your steering control
which could cause an accident and severe bodily injury.
Shift to P to edit settings
This warning message appears if you ...
Whenever the vehicle battery is disconnected or discharged, you must reset your
sunroof system as follows:
1.Start the engine.
2.Close the sunshade and sunroof completely if opened.
3.Release the sunroof control lever.
4.Push the sunroof control lever forward in the direction of close (about 1 ...