Kia Stinger: Engine Control System / Ambient Temperature Sensor (ATS)
Specifications
Temperature[⁰C(⁰F)]
|
Resistance(kΩ)
|
-40(-40)
|
811.1 - 956.8
|
-20(-4)
|
255.6 - 287.7
|
0(32)
|
91.5 - 98.8
|
20(68)
|
36.6 - 38.0
|
30(86)
|
23.8 - 24.7
|
40(104)
|
15.7 - 16.6
|
50(122)
|
10.6 - 11.3
|
60(140)
|
7.2 - 7.9
|
80(176)
|
3.6 - 4.0
|
Description and operation
Installed on the front-end module, the Ambient Temperature Sensor (ATS) senses
the ambient temperature. ECM receives the intake air temperature and ambient air
temperature at the same time to precisely control the intake air quantity supplied
through the turbocharger. The electrical resistance of the thermistor decreases
as the temperature increases, and vice versa. This sensor has a Negative Temperature
Coefficient (NTC) and its resistance is in inverse proportion to the temperature.

Schematic diagrams


Harness Connector

Repair procedures
1. |
Switch "OFF" the ignition.
|
2. |
Disconnect the ATS connector.
|
3. |
Measure resistance between the ATS terminals 1 and 2.
|
4. |
Check that the resistance is within the specification.
Temperature[⁰C(⁰F)]
|
Resistance(kΩ)
|
-40(-40)
|
811.1 - 956.8
|
-20(-4)
|
255.6 - 287.7
|
0(32)
|
91.5 - 98.8
|
20(68)
|
36.6 - 38.0
|
30(86)
|
23.8 - 24.7
|
40(104)
|
15.7 - 16.6
|
50(122)
|
10.6 - 11.3
|
60(140)
|
7.2 - 7.9
|
80(176)
|
3.6 - 4.0
|
|
1. |
Switch "OFF" the ignition and disconnect the negative (-) battery terminal.
|
2. |
Remove the front engine room under cover.
(Refer to Engjne Mechanical System - "Engine Room Under Cover")
|
3. |
Disconnect the connector (A) and then remove the ambient temperature
sensor (B).

|
Note that internal damage may occur when the component is dropped. If
the component has been dropped, inspect before installing.
|
1. |
Install in the reverse order of removal.
|
Specifications
Specification
Accelerator
Position
Output Voltage (V) [Vref = 5V]
APS1
APS2
C.T
0. ...
Specifications
Specification
Item
Specification
Coil Resistance (Ω)
1.4 - 1.6 [20°C(68°F)]
Description and operati ...
Other information:
After selecting a proper child seat for your child, check to make sure it fits
properly in your vehicle. Follow the instructions provided by the manufacturer when
installing the child seat. Note these general steps when installing the seat to
your vehicle:
Properly secure the child restrai ...
A battery should last for several years, but if the smart key is not working
properly, try replacing the battery with a new one. If you are unsure how to use
or replace the battery, contact an authorized Kia dealer.
IC WARNING
This device complies with Industry Canada licenceexempt RSS standar ...