Kia Stinger: Power Train / Fuel Filter (For Diesel engine only)
Repair procedures
1. |
Switch "OFF" the ignition and disconnect the negative (-) battery terminal.
|
2. |
Remove the engine cover (A).

|
3. |
Disconnect the water sensor connector & fuel heater connector (A), fuel
pressure sensor connector (B).
|
4. |
Disconnect the fuel inlet tube line quick-connector (C),from the fuel
filter.

|
5. |
Remove the fuel filter bracket installation bolts (A), and then remove
the fuel filter from the vehicle.

|
6. |
Remove the fuel filter installation bolts, and then remove the fuel filter
assembly from the bracket.

|
1. |
Install in the reverse order of removal.
After removing or replacing the following parts, bleed air in
low pressure fuel circuit.
(Refer to Fuel Delivery System - "Air bleeding in low pressure
fuel circuit")
–
|
High Pressure Fuel Pump
|
|
|
Repair procedures
Inspection
1.
Visually check the pipes, hangers and connections for severe corrosion,
leaks or damage.
2.
Check for unusual ...
Repair procedures
Inspection
[On vehicle inspection]
1.
Accelerate the engine to about 3,000 rpm 3 times or more.
2.
Remove the spark ...
Other information:
1. Open the liftgate.
2. Remove the service cover of both side (drive side and passenger side).
3. Remove the nuts from rear combination lamp of both side (drive side and passenger
side).
4. Disconnect the connector from rear combination lamp of both side (drive side
and passenger side) ...
Repair procedures
Inspection
1.
In the body electrical system, failure can be quickly diagnosed by using
the vehicle diagnostic system (KDS).
The diagnostic system (KDS) provides the following information.
(1)
Self diagnosis : Checking fail ...