Kia Stinger CK: Special driving conditions / Highway driving

Kia Stinger (CK) 2018-2023 Owner's Manual / Driving your vehicle / Special driving conditions / Highway driving

Contents:

Tires
Fuel, engine coolant and engine oil
Drive belt

Tires

Adjust the tire inflation pressures to specification. Low tire inflation pressures will result in overheating and possible failure of the tires.

Avoid using worn or damaged tires which may result in reduced traction or tire failure.

Never exceed the maximum tire inflation pressure shown on the tires.

WARNING - Under/over inflated tires

Always check the tires for proper inflation before driving. Underinflated or overinflated tires can cause poor handling, loss of vehicle control, and sudden tire failure leading to accidents, injuries, and even death. For proper tire pressures, refer to “Tires and wheels” in chapter 8.

WARNING - Tire tread

Always check the tire tread before driving your vehicle. Worn-out tires can result in loss of vehicle control.Worn-out tires should be replaced as soon as possible. For further information and tread limits, refer to "Tires and wheels" in chapter 7.

Fuel, engine coolant and engine oil

High speed travel consumes more fuel than urban motoring. Do not forget to check both the engine coolant and engine oil.

Drive belt

A loose or damaged drive belt may result in overheating of the engine.

Special driving conditions

Winter driving

Other information:

Kia Stinger (CK) 2018-2023 Owner's Manual: Driver’s attention

The driver must be cautious in the following situations because the system is limited when recognition of the lane marker is poor or limited: ►When lane and road condition is poor - It is difficult to distinguish the lane marker from road when the lane marker is covered with dust or sand. - It is difficult to distinguish the color of the lane marker from road.

Kia Stinger (CK) 2018-2023 Owner's Manual: Automatic Transmission Control System

Description and operation Description Automatic transmission control system relies on various measurements to determine the current control status and determine the necessary compensation values. These values are used to control the actuators and achieve the desired control output. Control System Composition Shift By Wire (SBW) System Composition ▶ Operating Principle – Instead of cable, the system uses electronic signals to shift between the P-R-N-D gears.