Kia Stinger: Evaporative Emission Control System / Fuel Tank Air Filter

Kia Stinger CK 2018-2025 Service Manual / Emission Control System / Evaporative Emission Control System / Fuel Tank Air Filter

Repair procedures
Removal
1.

Switch "OFF" the ignition and disconnect the negative (-) battery terminal.

2.

Remove the rear-left wheel & tire and wheel house cover.

3.

Disconnect the vent hose quick-connector (A).

4.

Remove the fuel tank air filter after removing the bolts (B).

Installation
1.

Install in the reverse order of removal.

Fuel Filler Cap
Description and operation Description A ratchet tightening device on the threaded fuel filler cap reduces the chances of incorrect installation, which seals the fuel filler. After the ...

Exhaust Emission Control System
Description and operation Description Exhaust emissions (CO, HC, NOx) are controlled by a combination of engine modifications and the addition of special control components. Modifica ...

Other information:

Kia Stinger CK 2018-2025 Service Manual: Start/Stop Button


Components and components location Components Repair procedures Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad passenger side panal. (Refer to Body - "Crash Pad Center Panel") ...

Kia Stinger CK 2018-2025 Service Manual: Auto Defogging Sensor (DATC only)


Description and operation Description Installed on the windshield glass, the auto defogging sensor judges and sends signal to blow out wind for defogging if moisture occurs. On receiving the signal from the sensor, the air conditioner control module restrains moisture and eliminate ...

Copyright © www.kstinger.com 2015-2025