Kia Stinger CK: Features of your vehicle / Wipers and washers

Contents:

A : Wiper speed control (front)

· MIST – Single wipe
· OFF – Off
· INT – Intermittent wipe

AUTO* – Auto control wipe

· LO – Low wiper speed
· HI – High wiper speed

B : Intermittent control wipe time adjustment

C :Wash with brief wipes (front)*

Windshield wipers ➤

Front windshield washers

In the OFF position, pull the lever gently toward you to spray washer fluid on the windshield and to run the wipers 1-3 cycles.

Use this function when the windshield is dirty.

The spray and wiper operation will continue until you release the lever.

If the washer does not work, check the washer fluid level. If the fluid level is not sufficient, you will need to add appropriate non-abrasive windshield washer fluid to the washer reservoir.

The reservoir filler neck is located in the front of the engine compartment on the passenger side.

CAUTION - Washer pump

To prevent possible damage to the washer pump, do not operate the washer when the fluid reservoir is empty.

WARNING - Obscured visibility

Do not use the washer in freezing temperatures without first warming the windshield with the defrosters; the washer solution could freeze on the windshield and obscure your vision.

CAUTION - Wipers & windshields

  • To prevent possible damage to the wipers or windshield, do not operate the wipers when the windshield is dry.
  • To prevent damage to the wiper blades, do not use gasoline, kerosene, paint thinner, or other solvents on or near them.
  • To prevent damage to the wiper arms and other components, do not attempt to move the wipers manually.

Other information:

Kia Stinger (CK) 2018-2023 Owner's Manual: Ambient Temperature Sensor

Description and operation Description Located in front of the condenser, the ambient temperature sensor detects the ambient air temperature. It is a negative type thermistor; resistance will increase with lower temperature, and decrease with higher temperature. The sensor output will be used for discharging temperature control, temperature regulation door control, blower motor level control, mix mode control and in-car humidity control.

Kia Stinger (CK) 2018-2023 Owner's Manual: Blind-Spot Collision Warning (BCW) Radar Calibration

Repair procedures Inspection Correction Overview Need to calibrate the mounting angle of the BCW when a vehicle has a rear or a side collision with BCW system even just replacing a BCW bracket or BCW components. Check before Correction 1. When a failure code [C2702 (Master)] or [C2703 (Slave)] occurs, check the following before performing correction.

Categories

 
Copyright © 2026 www.kstinger.com 0.0098