Kia Stinger CK: Special driving conditions / Highway driving

Kia Stinger (CK) 2018-2023 Owner's Manual / Driving your vehicle / Special driving conditions / Highway driving

Contents:

Tires
Fuel, engine coolant and engine oil
Drive belt

Tires

Adjust the tire inflation pressures to specification. Low tire inflation pressures will result in overheating and possible failure of the tires.

Avoid using worn or damaged tires which may result in reduced traction or tire failure.

Never exceed the maximum tire inflation pressure shown on the tires.

WARNING - Under/over inflated tires

Always check the tires for proper inflation before driving. Underinflated or overinflated tires can cause poor handling, loss of vehicle control, and sudden tire failure leading to accidents, injuries, and even death. For proper tire pressures, refer to “Tires and wheels” in chapter 8.

WARNING - Tire tread

Always check the tire tread before driving your vehicle. Worn-out tires can result in loss of vehicle control.Worn-out tires should be replaced as soon as possible. For further information and tread limits, refer to "Tires and wheels" in chapter 7.

Fuel, engine coolant and engine oil

High speed travel consumes more fuel than urban motoring. Do not forget to check both the engine coolant and engine oil.

Drive belt

A loose or damaged drive belt may result in overheating of the engine.

Special driving conditions

Winter driving

Other information:

Kia Stinger (CK) 2018-2023 Owner's Manual: Securing a child restraint with a lap/shoulder belt

When not using the LATCH system, all child restraints must be secured to a vehicle rear seat with the lap part of a lap/shoulder belt. Automatic locking mode Since all passenger seat belts move freely under normal conditions and only lock under extreme or emergency conditions (emergency locking mode), you must manually pull the seat belt all the way out to shift the retractor to the “Automatic Locking” mode to secure a child restraint.

Kia Stinger (CK) 2018-2023 Owner's Manual: Wide Sunroof Assembly

Components and components location Components Location 1. Wide sunroof assembly Repair procedures Removal • To remove the panorama sunroof assembly, use the tools shown in the following figure: [Tools Composition] ① Square wire ② Insert-type wire grip [Tool Assembly] • Insert and affix square wire ① into the insert hole of the wire grip ②.