Kia Stinger CK: Automatic transmission / Launch Control

Contents:

Launch Control Operation

  • When using Launch Control, a driver should always make sure that the engine’s cooling water is warmed up and reaches a recommended temperature.
  • To operate ESC Off state 2, Press and hold ESC button for more than 3 seconds in Sports mode. (Status Display on Cluster Screen)
  • For launching, stop the vehicle and keep the steering wheel straight.
  • Footbrakes, EPB and Auto Hold must be released for smooth launching.

  • Press the brake firmly with your left foot in transmission D mode, while pressing the accelerator pedal down fully with your right foot. Then, the Launch Control Ready (1) will be in place.

  • To start a vehicle, with your right foot pressing the accelerator pedal down fully, remove your left foot from the brake. (within 4 seconds) (Launch Control Active (2) Status Display on Cluster Screen)
  • If both the brakes and accelerater pedals were applied and the driver removes his foot only from the accelerater pedal, Launch Control will be automatically deactivated. Or, if the vehicle does not start after 4 seconds with a driver’s feet on both brake and accelerate pedals, Launch Control will automatically deactivated as well.
  • Do not operate both brake and accelerate pedals simultaneously for longer than 4 seconds.
  • When re-using Launch Control, a driver should have the vehicle cool down sufficiently by driving.

Limited use of Launch Control (3)

  • A warning message will pop up on the screen if the transmission fluid temperature is above a certain level while using Launch Control. Also, Launch Control will be automatically deactivated.
  • To address the issue as above, a driver should cool down the transmission fluid temperature by driving the vehicle. (Driving at a constant speed over 60 km/h (37 mph) is highly recommended, but this should only be done if traffic and road conditions permit the driver to do so safely.)

WARNING

It is the responsibility of the driver to make sure it is safe before using Launch Control. Do not use Launch Control on public roads or when pedestrian congestion is present. Doing so could result in an accident that causes serious injuries.

✽ NOTICE

Launch performance can vary depending on fuel, environment, tire, and loading conditions.

CAUTION

Constant use of Launch Control can put enormous stress on transmission, engine, and drive shafts and can result in vehicle damage. It is highly recommended that Launch Control is used after completion of the vehicle brake-in process.

Other information:

Kia Stinger (CK) 2018-2023 Owner's Manual: Changing tires

1. Park on a level surface and apply the parking brake firmly. 2. Place the transaxle shift lever in P (Park). 3. Activate the hazard warning flashers. 4. Remove the wheel lug nut wrench, jack and spare tire from the vehicle. 5. Block both the front and rear of the wheel that is diagonally opposite from the jack position. WARNING - Jack location To reduce the possibility of injury, be sure to use only the jack provided with the vehicle in the correct jack position; never use any other part of the vehicle for jack support.

Kia Stinger (CK) 2018-2023 Owner's Manual: Explanation of scheduled maintenance items

Engine oil and filter The engine oil and filter should be changed at the intervals specified in the maintenance schedule. If the vehicle is being driven in severe conditions, more frequent oil and filter changes are required. Drive belts Inspect all drive belts for evidence of cuts, cracks, excessive wear or oil saturation and replace if necessary.

Categories

 
Copyright © 2026 www.kstinger.com 0.0076