Kia Stinger CK: Automatic transmission (shift-by-wire) / LCD display messages

Kia Stinger (CK) 2018-2023 Owner's Manual / Driving your vehicle / Automatic transmission (shift-by-wire) / LCD display messages

Contents:

Shifter Malfunction
Check shift lever
Shifting conditions not met
Press brake pedal to change gear
Shift to P after stopping
Press UNLOCK to change gear
PARK engaged
NEUTRAL engaged

Shifter Malfunction

The warning message appears on the LCD display, when the transmission or the shift lever does not properly operate in the P (Park) position. In this case, we recommend you to immediately have the vehicle inspected by an authorized Kia dealer.

Check shift lever

The warning message appears on the LCD display, when there is a malfunction with one of the key transmission components.

In this case, have the vehicle inspected by an authorized Kia dealer immediately.

Shifting conditions not met

The warning message appears on the LCD display, when engine RPM is too high, or when driving speed is too fast to shift the gear.

We recommend you decrease your RPM level or slow down before shifting the gear.

Press brake pedal to change gear

The warning message appears on the LCD display, when the brake pedal is not depressed while shifting the gear.

We recommend you depress the brake pedal and then shift the gear.

Shift to P after stopping

The warning message appears on the LCD display, when the brake pedal is not depressed while shifting the gear.

We recommend you depress the brake pedal and then shift the gear.

Press UNLOCK to change gear

The warning message appears on the LCD display, when the [UNLOCK] button is not pressed while shifting the gear.

We recommend you press the [UNLOCK] button and then shift the gear.

PARK engaged

The message appears on the LCD display, when the P (Park) position is engaged.

NEUTRAL engaged

The message appears on the LCD display, when the N (Neutral) position is engaged.

Transmission ranges

Good driving practices

Other information:

Kia Stinger (CK) 2018-2023 Owner's Manual: SRS components and functions

The SRS consists of the following components: 1. Driver's front air bag module 2. Passenger's front air bag module 3. Side air bag modules 4. Curtain air bag modules 5. Retractor pre-tensioner assemblies 6. Air bag warning light 7. SRS control module (SRSCM) / Rollover sensor 8. Front impact sensors 9. Side impact sensors 10. PASSENGER AIR BAG “OFF” indicator (Front passenger’s seat only) 11.

Kia Stinger (CK) 2018-2023 Owner's Manual: ECS-G Sensor

Repair procedures Removal [Body G Sensor] Front 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove wheel nuts, wheel and tire (A) from hub. Tightening torque: 107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94.0 lb·ft) Be careful not to damage the wheel bolts when removing the wheel and tire (A).