Contents:

Pull the sunroof control lever backward to the 2nd detent position, and both the sunshade and sunroof glass will slide all the way open.
Pull the sunroof control lever back ward to the 1st or 2nd detent position, the sunroof glass will slide all the way open. To stop the sunroof movement at any point, push the sunroof control lever momentarily.

If an object or part of the body is detected while the sunroof is closing automatically, it will reverse the direction, and then stop.
The auto reverse function may not work if a tiny obstacle is lodged between the sliding glass and the sunroof sash. You should always check that all passengers and objects are away from the sunroof before closing it.
Objects less than 4 mm (0.16 inch) in diameter caught between the sunroof glass and the front glass channel may not be detected by the automatic reverse glass and the glass will not stop and reverse direction.
WARNING - Sunroof
WARNING - Sunroof Operation
When closing the sunroof, make sure there are no body parts in the movement range of the sliding roof. Parts of the body could become trapped or crushed.
CAUTION
To prevent damage to the sunroof, periodically remove any dirt that may accumulate on the guide rail.
✽ NOTICE
If you drive with the sunroof opened right after a vehicle wash or rain, water may get inside the vehicle.
CAUTION - Sunroof motor damage
If you try to open the sunroof when the temperature is below freezing or when the sunroof is covered with snow or ice, the glass or the motor could be damaged.
Kia Stinger (CK) 2018-2023 Owner's Manual: Front Door
Components and components location Components 1. Front door trim panel 2. Front door module 3. Front door panel 4. Front door channel 5. Front door side weatherstrip 6. Front door frame garnish 7. Front door body side weatherstrip 8. Front door inside handle cover 9. Front door belt inner weatherstrip 10.Kia Stinger (CK) 2018-2023 Owner's Manual: Rear Axle Assembly
Components and components location Components 1. Rear brake disc 2. Hub assembly 3. Dust cover 4. Rear knuckle Repair procedures Removal 1. Remove wheel nuts, rear wheel and tire (A) from rear hub. Tightening torque : 107.9 - 127.5 N·m (11.