Kia Stinger: Door locks / Operating door locks from outside the vehicle

- After removing the cover (2) while pressing the hole (1) using mechanical
key or screw driver (-), turn the key (3) toward the front of the vehicle to
unlock and toward the rear of the vehicle to lock.
- If you lock/unlock the driver’s door with a key, only the driver’s door
will lock/unlock.
- Once the doors are unlocked, they may be opened by pulling the door handle.
- When closing the door, push the door by hand. Make sure the doors are closed
securely.
✽ NOTICE
- In cold and wet climates, door lock and door mechanisms may not work
properly due to freezing conditions.
- If the door is locked/unlocked multiple times in rapid succession with
either the vehicle key or door lock switch, the system may stop operating temporarily
in order to protect the circuit and prevent damage to system components.
CAUTION
Do not unnecessarily open and close the door repeatedly or with excessive
force. Such action can damage the vehicle door.

- To lock a door without the key, push the inside door lock button (1) or
central door lock switch (2) to the “Lock” position and close the door (3).
- If you lock the door with the central door lock switch (2), all vehicle
doors will lock automatically.
✽ NOTICE
Always place the Engine Start/Stop button is in the OFF position, engage the
parking brake, close all windows, and lock all doors when leaving your vehicle unattended.
With the door lock button
To unlock a door, push the door lock button (1) to the “Unlock” position.
The red mark on the handle will be visible.
To lock a door, push the door lock button ...
Other information:
A battery should last for several years, but if the smart key is not working
properly, try replacing the battery with a new one. If you are unsure how to use
or replace the battery, contact an authorized Kia dealer.
IC WARNING
This device complies with Industry Canada licenceexempt RSS standar ...
Operates as follows when the ignition switch is turned ON.
MIST : For a single wiping cycle, move the lever to this (MIST) position and
release it. The wipers will operate continuously if the lever is held in this position.
OFF : Wiper is not in operation
INT : Wiper operates intermittently at ...