Contents:

✽ NOTICE
CAUTION
Do not unnecessarily open and close the door repeatedly or with excessive force. Such action can damage the vehicle door.

✽ NOTICE
Always place the Engine Start/Stop button is in the OFF position, engage the parking brake, close all windows, and lock all doors when leaving your vehicle unattended.

The child safety lock is provided to help prevent children from accidentally opening the rear doors from inside the vehicle. The rear door safety locks should be used whenever children are in the vehicle.
1. Open the rear door.
2. Turn the child safety lock (1) located on the rear edge of the door to the
lock (
) position. When the child safety
lock is in the lock position, the rear door will not open even when the inner door
handle is pulled.
3. Close the rear door.
To open the rear door, pull the outside door handle (2).
Even though the doors may be unlocked, the rear door will not open by pulling the inner door handle until the rear door child safety lock is unlocked.
WARNING - Rear door locks
Use the rear door safety locks whenever children are in the vehicle. If a child accidently opens the rear doors while the vehicle is moving, they may fall out.
Kia Stinger (CK) 2018-2023 Owner's Manual: Coolant
Repair procedures Refilling And Bleeding Never remove the radiator cap when the engine is hot. Serious scalding could be caused by hot fluid under high pressure escaping from the radiator. When pouring engine coolant, be sure to shut the relay box lid and not to let coolant spill on the electrical parts or the paint.Kia Stinger (CK) 2018-2023 Owner's Manual: Smart Cruise Control (Stop & Go) (SCC) ECU
Description and operation Description The smart cruise control unit is installed on the front right-hand side of the chassis. A radar sensor is embedded in the front section of the unit. This sensor detects vehicles and objects in front of the vehicle. The radar sensor can detect up to 64 objects ahead of the vehicle. The alarm goes off when the vehicle deviates from the horizontal and vertical alignment reference points during operation.