Kia Stinger: Tires and wheels / Wheel alignment and tire balance, Flat Spots

Kia Stinger CK 2018-2024 Owners Manual / Maintenance / Tires and wheels / Wheel alignment and tire balance, Flat Spots

Wheel alignment and tire balance

The wheels on your vehicle were aligned and balanced carefully at the factory to give you the longest tire life and best overall performance.

In most cases, you will not need to have your wheels aligned again. However, if you notice unusual tire wear or your vehicle pulling one way or the other, the alignment may need to be reset.

If you notice your vehicle vibrating when driving on a smooth road, your wheels may need to be rebalanced.

CAUTION - Wheel weight

Improper wheel weights can damage your vehicle's aluminum wheels. Use only approved wheel weights.

Flat Spots

If a vehicle is parked/not operated for a long period of time, tires may develop “flat spots”. Once the vehicle is driven again, these flat spots may cause a vibration which typically disappears gradually as the tires warm up and regain their original shape. To minimize tire flat spots developing during periods of extended storage, inflate the tires to the maximum pressure as indicated on the tire’s sidewall. When the vehicle is made ready to drive again, lower the tire pressure to the recommended levels as shown on the Tire and Loading Information label in the driver’s side center pillar for your vehicle (Refer to “Tire specification and pressure label” in chapter 8).

Tire rotation
To equalize tread wear, it is recommended that the tires be rotated every 10,000 km (6,000 miles) or sooner if irregular wear develops. During rotation, check the tires for correct balance. When r ...

Tire replacement
If the tire is worn evenly, a tread wear Indicator (A) will appear as a solid band across the tread. This shows there is less than 1.6 mm (1/16 inch) of tread left on the tire. Replace the tire ...

Other information:

Kia Stinger CK 2018-2024 Owners Manual: Driver’s attention


The driver must be cautious in the following situations because the system is limited when recognition of the lane marker is poor or limited: ►When lane and road condition is poor - It is difficult to distinguish the lane marker from road when the lane marker is covered with dust or sand. - ...

Kia Stinger CK 2018-2024 Service Manual: Active hood sensor & unit assembly


Repair procedures Replacement 1. Disconnect the negative battery terminal.    After disconnecting the cables, wait at least 30 seconds. 2. ...

Copyright © www.kstinger.com 2015-2024