Kia Stinger CK: Tires and wheels / Recommended cold tire inflation pressures
All tire pressures (including the spare) should be checked when the tires are
cold. “Cold Tires” means the vehicle has not been driven for at least three hours
or driven less than 1.6 km (one mile).
Recommended pressures must be maintained for the best ride, top vehicle handling,
and minimum tire wear.
For recommended inflation pressure refer to “Tire and wheels” in chapter 8.

All specifications (sizes and pressures) can be found on a label attached to
the driver’s side center pillar.
WARNING - Checking the tire inflation pressure
Inflate your tires consistent with the instructions provided in this manual.
Regularly check the tire inflation pressure, and correct it as needed: at
least twice a month and before a long trip.
If you fail to observe this precaution, you may be driving on tires with incorrect
tire pressures, a condition that may not only compromise your vehicle's driving
stability, but also lead to tire damage and the risk of an accident.
This risk is much higher on hot days and when driving for long periods at
high speeds.
- Underinflation also results in excessive wear, poor handling and reduced
fuel economy. Wheel deformation also is possible. Keep your tire pressures at
the proper levels. If a tire frequently needs refilling, have it checked by
an authorized Kia dealer.
- Overinflation produces a harsh ride, excessive wear at the center of the
tire tread, and a greater possibility of damage from road hazards.
- Warm tires normally exceed recommended cold tire pressures by 28 to 41 kPa
(4 to 6 psi). Do not release air from warm tires to adjust the pressure or the
tires will be underinflated.
- Be sure to reinstall the tire inflation valve caps. Without the valve cap,
dirt or moisture could get into the valve core and cause air leakage. If a valve
cap is missing, install a new one as soon as possible.
Other information:
Kia Stinger (CK) 2018-2023 Owner's Manual: Engine Mounting
Components and components location
Components
1. Engine mounting support bracket
(LH)
2. Engine mounting support bracket (RH)
3. Engine mounting bracket (LH)
4. Engine mounting bracket (RH)
5. Transmission mounting bracket (AWD)
6. Transmission mounting bracket (2WD)
Repair procedures
Removal and Installation
Engine Mounting Bracket
1.
Kia Stinger (CK) 2018-2023 Owner's Manual: AVN Head Unit
Components and components location
Components
Connector Pin Information
No.
Connector A
Connector B
Connector C
Connector D
Internal Amplifier
External Amplifier
1
Rear door left speaker (+)
-
-
-
Ground
2
Rear door left speaker (-)
-
MIC (+)