Kia Stinger: Maintenance / Checking fluid levels
When checking engine oil, engine coolant, brake fluid, and washer fluid, always
be sure to clean the area around any filler plug, drain plug, or dipstick before
checking or draining any lubricant or fluid. This is especially important in dusty
or sandy areas and when the vehicle is used on unpaved roads. Cleaning the plug
and dipstick areas will prevent dirt and grit from entering the engine and other
mechanisms that could be damaged.
Engine oil and filter
The engine oil and filter should be changed at the intervals specified in the
maintenance schedule. If the vehicle is being driven in severe conditions, more
frequent oil an ...
Checking the engine oil level
■ THETA II 2.0L T-GDI Engine (Gasoline)
■ Lambda II PE 3.3L T-GDI Engine (Gasoline)
1. Be sure the vehicle is on level ground.
2. Start the engine and allow i ...
Other information:
Repair procedures
Inspection
1.
Check the drive shaft boots for loose clamps, cracks, grease leaks, kinks
or damage.
...
The Blind-Spot Collision Warning (BCW) system uses radar sensors in the rear
bumper to monitor and warn the driver of an approaching vehicle in the driver's
blind spot area.
The system monitors the rear area of the vehicle and provides information to
the driver with an audible alert and a i ...