Kia Stinger: Engine And Transmission Assembly / Engine Room Under Cover
Repair procedures
Engine Room Front Under
Cover.
1. |
Remove the engine room front under cover (A).
Tightening torque :
7.8 - 11.8 N·m (0.8 - 1.2 kgf·m, 5.8 - 8.7 lb·ft)
|

|
2. |
Install in the reverse order of removal.
|
Engine Room Rear Under
Cover.
1. |
Remove the engine room rear under cover (A).
Tightening torque :
7.8 - 11.8 N·m (0.8 - 1.2 kgf·m, 5.8 - 8.7 lb·ft)
|

|
2. |
Install in the reverse order of removal.
|
Engine Room Side Cover
[AWD]
1. |
Remove the engine room front under cover.
|
2. |
Remove the engine room front side cover (A).
Tightening torque :
7.8 - 11.8 N·m (0.8 - 1.2 kgf·m, 5.8 - 8.7 lb·ft)
|
[RH]

[LH]

|
3. |
Remove the engine room rear side cover (A).
Tightening torque :
7.8 - 11.8 N·m (0.8 - 1.2 kgf·m, 5.8 - 8.7 lb·ft)
|
[RH]

[LH]

|
4. |
Install in the reverse order of removal.
|
Engine Room Side Cover
[2WD]
1. |
Remove the engine room front under cover.
|
2. |
Remove the front stabilizer bar from the sub frame.
(Refer to Suspension System - "Front Stabilizer Bar")
|
3. |
Remove the engine room side cover (A).
Tightening torque :
7.8 - 11.8 N·m (0.8 - 1.2 kgf·m, 5.8 - 8.7 lb·ft)
|
[RH]

[LH]

|
4. |
Install in the reverse order of removal.
|
Repair procedures
Removal and Installation
1.
Remove the engine cover (A).
...
Components and components location
Components
1. Engine mounting support bracket
(LH)
2. Engine mounting support bracket (RH)
3. Engine mounting bracket (LH)
...
Other information:
Wheel alignment and tire balance
The wheels on your vehicle were aligned and balanced carefully at the factory
to give you the longest tire life and best overall performance.
In most cases, you will not need to have your wheels aligned again. However,
if you notice unusual tire wear or your ve ...
Components and components location
Components
1. Water temperature control
assembly
2. Engine coolant temperature sensor
3. Water outlet hose
4. Heater hose
5. Intake manifold water hose
6. Oil cooler hose
Repair procedu ...