Kia Stinger CK: Driving your vehicle / Automatic transmission

Kia Stinger (CK) 2018-2023 Owner's Manual / Driving your vehicle / Automatic transmission

Contents:

Automatic transmission operation ➤

Good driving practices

Never move the gear shift lever from P (Park) to any other position with the accelerator pedal depressed.
Never move the gear shift lever into P (Park) when the vehicle is in motion.
Slow down before shifting to a lower gear. Otherwise, the lower gear may not be engaged.
Always use the parking brake. Do not depend on placing the transmission in P (Park) to keep the vehicle from moving.
Optimum vehicle performance and economy is obtained by smoothly depressing and releasing the accelerator pedal.

✽ NOTICE - Kickdown Mechanism

Use the kickdown mechanism for maximum acceleration. Depress the accelerator pedal beyond the pressure point. The automatic transmission will shift to a lower gear depending on the engine speed.

Moving up a steep grade from a standing start

To move up a steep grade from a standing start, depress the brake pedal, release the parking brake, and shift the shift lever to D (Drive). Depress the accelerator gradually while releasing the brake pedal.

Launch Control ➤

Starting the engine with a smart key

Automatic transmission operation

Other information:

Kia Stinger (CK) 2018-2023 Owner's Manual: ESP(Electronic Stability Program) System

Components and components location Components Location 1. HECU module 2. Front wheel speed sensor (2WD) 3. Front wheel speed sensor (AWD) 4. Rear wheel speed sensor Description and operation Description of ESP Electronic Stability Program (ESP) recognizes critical driving conditions, such as panic reactions in dangerous situations, and stabilizes the vehicle by wheel-individual braking and engine control intervention.

Kia Stinger (CK) 2018-2023 Owner's Manual: Rear Oil Seal

Repair procedures Replacement 1. Remove the automatic transmission. (Refer to Automatic Transmission System - "Automatic Transmission") 2. Remove the drive plate. (Refer to Cylinder Block - "Drive Plate") 3. Remove the rear oil seal (A). 4.