Kia Stinger CK: Automatic transmission (shift-by-wire) / Launch Control
Contents:
Launch Control Operation
- When using Launch Control, a driver should always make sure that the engine’s
cooling water is warmed up and reaches a recommended temperature.
- To operate ESC Off state 2, Press and hold ESC button for more than 3 seconds
in Sports mode. (Status Display on Cluster Screen)
- For launching, stop the vehicle and keep the steering wheel straight.
- Footbrakes, EPB and Auto Hold must be released for smooth launching.

- Press the brake firmly with your left foot in transmission D mode, while
pressing the accelerator pedal down fully with your right foot. Then, the Launch
Control Ready (1) will be in place.

- To start a vehicle, with your right foot pressing the accelerator pedal
down fully, remove your left foot from the brake. (within 4 seconds) (Launch
Control Active (2) Status Display on Cluster Screen)
- If both the brakes and accelerater pedals were applied and the driver removes
his foot only from the accelerater pedal, Launch Control will be automatically
deactivated. Or, if the vehicle does not start after 4 seconds with a driver’s
feet on both brake and accelerate pedals, Launch Control will automatically
deactivated as well.
- Do not operate both brake and accelerate pedals simultaneously for longer
than 4 seconds.
- When re-using Launch Control, a driver should have the vehicle cool down
sufficiently by driving.
Limited use of Launch Control (3)

- An warning message will pop up on the screen if the transmission fluid temperature
is above a certain level while using Launch Control. Also, Launch Control will
be automatically deactivated.
- To address the issue as above, a driver should cool down the transmission
fluid temperature by driving the vehicle. (Driving at a constant speed over
60 km/h (37 mph) is highly recommended, but this should only be done if traffic
and road conditions permit the driver to do so safely.)
WARNING
It is the responsibility of the driver to make sure it is safe before using
Launch Control. Do not use Launch Control on public roads or when pedestrian congestion
is present. Doing so could result in an accident that causes serious injuries.
✽ NOTICE
Launch performance can vary depending on fuel, environment, tire, and loading
conditions.
CAUTION
Constant use of Launch Control can put enormous stress on transmission, engine,
and drive shafts and can result in vehicle damage. It is highly recommended that
Launch Control is used after completion of the vehicle brake-in process.
Other information:
Kia Stinger (CK) 2018-2023 Owner's Manual: AWD Control System
Components and components location
Components Location
1. AWD
ECU
Description and operation
Description
The AWD ECU distributes the driving force to the front/rear wheel through controlling
the multi plate clutch on the AWD transfer case by analyzing the input information,
i.e. the wheel speed, accelerator and steering angle depending on the road condition
and driving state.
Kia Stinger (CK) 2018-2023 Owner's Manual: Evaporative Emission Control System
Description and operation
Description
Evaporative Emission Control System prevents fuel vapor stored in fuel tank from
vaporizing into the atmosphere. When the fuel evaporates from the fuel tank, the
vapor passes through vent hoses or tubes into canister filled with charcoal and
the canister temporarily holds the vapor in the charcoal.