Kia Stinger CK: General Information / Lift And Support Points

General information
Lift And Support Points
  

When heavy rear components such as suspension, fuel tank, spare tire, tailgate and trunk lid are to be removed, place additional weight in the luggage area before hoisting. When substatial weight is removed from the rear of the vehicle, the center of gravity may change and can cause the vehicle to tip forward on the hoist.

  

Since each tire/wheel assembly weighs approximately 30 lbs (14 kg), placing the front wheels in the luggage area can assist with the weight distribution.

Use the same support points to support the vehicle on safety stands.

1.

Place the lift blocks under the support points as shown in the illustration.

2.

Raise the hoist a few inches (centimeters) and rock the vehicle to be sure it is firmly supported.

3.

Raise the hoist to full height to inspect the lift points for secure support.

Other information:

Kia Stinger (CK) 2018-2023 Service Manual: Curtain air bag

Curtain air bags are located along both sides of the roof rails above the front and rear doors. They are designed to help protect occupants in certain side impacts and to help prevent them from ejecting out of the vehicle as a result of a rollover, especially when the seatbelts are also in use. The curtain air bags are designed to deploy during certain side impact collisions, depending on the crash severity, angle, speed and point of impact.

Kia Stinger (CK) 2018-2023 Service Manual: Intake Manifold

Components and components location Components 1. Intake manifold 2. VCM actuator 3. Clip 4. VCM shaft 5. Intake manifold gasket 6. Intake manifold bracket (LH) 7. Intake manifold bracket (RH) Repair procedures Removal and Installation 1. Disconnect the negative battery terminal.

Categories

 
Copyright © 2026 www.kstinger.com 0.01