Contents:

Pull the sunroof control lever backward to the 2nd detent position, and both the sunshade and sunroof glass will slide all the way open.
Pull the sunroof control lever back ward to the 1st or 2nd detent position, the sunroof glass will slide all the way open. To stop the sunroof movement at any point, push the sunroof control lever momentarily.

If an object or part of the body is detected while the sunroof is closing automatically, it will reverse the direction, and then stop.
The auto reverse function may not work if a tiny obstacle is lodged between the sliding glass and the sunroof sash. You should always check that all passengers and objects are away from the sunroof before closing it.
Objects less than 4 mm (0.16 inch) in diameter caught between the sunroof glass and the front glass channel may not be detected by the automatic reverse glass and the glass will not stop and reverse direction.
WARNING - Sunroof
WARNING - Sunroof Operation
When closing the sunroof, make sure there are no body parts in the movement range of the sliding roof. Parts of the body could become trapped or crushed.
CAUTION
To prevent damage to the sunroof, periodically remove any dirt that may accumulate on the guide rail.
✽ NOTICE
If you drive with the sunroof opened right after a vehicle wash or rain, water may get inside the vehicle.
CAUTION - Sunroof motor damage
If you try to open the sunroof when the temperature is below freezing or when the sunroof is covered with snow or ice, the glass or the motor could be damaged.
Kia Stinger (CK) 2018-2023 Owner's Manual: Balance Shaft & Oil Pump
Repair procedures Removal BSM (Balance Shaft Module) Chain System 1. Remove the timing chain. (Refer to Timing System - "Timing Chain") 2. Install a stopper pin (A) after compressing the balance shaft chain tensioner. 3. Remove the balance shaft chain tensioner (B).Repair procedures Refilling And Bleeding Never remove the radiator cap when the engine is hot. Serious scalding could be caused by hot fluid under high pressure escaping from the radiator. When pouring engine coolant, be sure to shut the relay box lid and not to let coolant spill on the electrical parts or the paint.