Kia Stinger CK: Hood / Hood Lifter

Kia Stinger (CK) 2018-2023 Service Manual / Front Seat Belt / Hood / Hood Lifter

Repair procedures

Replacement

•	When removing and installing the hood lifter, work in a group of two or more.

•	When removing the hood lifter, first remove the lower portion and then upper portion.

1.	Using a screwdriver, lift the socket clips (A) up slightly on both ends of the lifter (B), and then remove the lifter from the bracket.

Push the socket of the lifter into the bracket for installation.

Make sure that the hood locks/unlocks and opens/closes properly.

Other information:

Kia Stinger (CK) 2018-2023 Service Manual: Rear Driveshaft Assembly

Repair procedures Removal 1. Remove wheel nuts, wheel and tire (A) from hub. Tightening torque: 107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94.0 lb·ft) Be careful not to damage the wheel nuts when removing the wheel and tire (A).

Kia Stinger (CK) 2018-2023 Service Manual: Height Sensor

Components and components location Components Description and operation Description Height sensor sense a change of vehicle height and send this signal to AFS ECU. Height sensor is comprised of rotor/stator, PCB coil and sensor lever. Sensor check the lever angle value which is calculated by the magnetic field of stator.

Kia Stinger CK: Hood / Hood Lifter

Repair procedures

Hood Assembly

Hood Latch Release Handle

Other information:

Categories