Kia Stinger CK: RCCW (Rear Cross-Traffic Collision Warning) / Warning type

  • If the vehicle detected by sensors approaches your vehicle, the warning chime will sound and the warning light will blink on the outside rearview mirror.
  • If the detected vehicle is out of detection range, moving away in the opposite direction or moving slow, or if the vehicle is right behind your vehicle, if the direction of the other vehicle is not heading towards your vehicle, the warning is cancelled.
  • The system may not operate properly due to other factors or circumstances. Always pay attention to your surroundings.

❈ If your vehicle's left or right side bumper is blinded by a barrier or vehicles, the system sensing abiliOCK057048 ty may be limited.

WARNING

  • The Blind-Spot Collision Warning System and Rear Cross-Traffic Collision Warning is not a substitute for proper driving procedures. Always drive safely and use caution when changing lanes or backing up. The Blind-Spot Collision Warning system and Rear Cross-Traffic Collision Warning may not detect every object alongside the vehicle.
  • When the BCW system is being activated, the warning light on the outside rearview mirror will illuminate whenever a vehicle is detected by the system. To avoid accidents, do not focus only on the warning light and neglect to see the surrounding of the vehicle.
  • Drive safely even though the vehicle is equipped with a BCW (Blind-Spot Collision Warning) system. Do not solely rely on the system but check for yourself before changing lanes. The system may not alert the driver in some conditions so always check the surroundings while driving.

✽ NOTICE

  • The system may not work properly if the bumper has been replaced or if repair work has been done near the sensor.
  • The detection area differs according to the road's width. If the road is narrow the system may detect other vehicles in the next lane.
  • If the road is very wide the system may not detect other vehicles.
  • The system may turn off due to strong electromagnetic interference.

Other information:

Kia Stinger (CK) 2018-2023 Owner's Manual: Vanity Lamp

Repair procedures Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the vanity lamp (A) using a flat-tip screwdriver. 3. Disconnect the vanity lamp connector (A). Installation 1. Connect the vanity lamp connector.

Kia Stinger (CK) 2018-2023 Owner's Manual: Timing Chain Cover

Repair procedures Removal    In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure fuel. So don’t do any repair work right after engine stops.    • Use fender covers to avoid damaging painted surfaces.

Categories

 
Copyright © 2026 www.kstinger.com 0.0122