Kia Stinger CK: Features of your vehicle / Wipers and washers

Contents:

A : Wiper speed control (front)

· MIST – Single wipe
· OFF – Off
· INT – Intermittent wipe

AUTO* – Auto control wipe

· LO – Low wiper speed
· HI – High wiper speed

B : Intermittent control wipe time adjustment

C :Wash with brief wipes (front)*

Windshield wipers ➤

Front windshield washers

In the OFF position, pull the lever gently toward you to spray washer fluid on the windshield and to run the wipers 1-3 cycles.

Use this function when the windshield is dirty.

The spray and wiper operation will continue until you release the lever.

If the washer does not work, check the washer fluid level. If the fluid level is not sufficient, you will need to add appropriate non-abrasive windshield washer fluid to the washer reservoir.

The reservoir filler neck is located in the front of the engine compartment on the passenger side.

CAUTION - Washer pump

To prevent possible damage to the washer pump, do not operate the washer when the fluid reservoir is empty.

WARNING - Obscured visibility

Do not use the washer in freezing temperatures without first warming the windshield with the defrosters; the washer solution could freeze on the windshield and obscure your vision.

CAUTION - Wipers & windshields

  • To prevent possible damage to the wipers or windshield, do not operate the wipers when the windshield is dry.
  • To prevent damage to the wiper blades, do not use gasoline, kerosene, paint thinner, or other solvents on or near them.
  • To prevent damage to the wiper arms and other components, do not attempt to move the wipers manually.

Other information:

Kia Stinger (CK) 2018-2023 Owner's Manual: Fender

Components and components location Component Location 1. Fender assembly Repair procedures Replacement    Be careful not to damage the fender and body.    When removing the clips, use a clip remover.

Kia Stinger (CK) 2018-2023 Owner's Manual: Engine compartment fuse replacement

1. Turn the ignition switch and all other switches off. 2. Remove the fuse panel cover by pressing the tab and pulling the cover up. When the blade type fuse is disconnected, remove it by using the clip designed for changing fuses located in the engine compartment fuse box. Upon removal, securely insert reserve fuse of the same rating. 3. Check the removed fuse; replace it if it is blown.

Categories

 
Copyright © 2025 www.kstinger.com 0.0097