Kia Stinger CK: Driving your vehicle / ISG (Idle Stop and Go) system

Contents:

Your vehicle may be equipped with the ISG system, which reduces fuel consumption by automatically shutting down the engine, when the vehicle is at a standstill. (For example : red light, stop sign and traffic jam)

The engine starts automatically as soon as the starting conditions are met.

The ISG system is ON whenever the engine is running.

✽ NOTICE

When the engine automatically starts by the ISG system, some warning lights (ABS, ESC, ESC OFF, EPS or Parking brake warning light) may turn on for a few seconds. This happens because of low battery voltage. It does not mean the system has malfunctioned.

Auto stop ➤

Auto start ➤

Condition of ISG system operation

The ISG system will operate under the following condition:

- The driver’s seat belt is fastened.
- The driver’s door and engine hood are closed.
- The brake vacuum pressure is adequate.
- The battery is sufficiently charged.
- The outside temperature is between 14°F to 95°F (-10°C to 35°C).
- The engine coolant temperature is not too low.

✽ NOTICE

  • If the ISG system does not meet the operation condition, the ISG system is deactivated. The light on the ISG OFF button will illuminate and a message “Auto Stop conditions not met” will appear on the LCD display.
  • If the light or notice comes on continuously, please check the operation condition.

ISG system deactivation

  • If you wish to deactivate the ISG system, press the ISG OFF button (1). The light on the ISG OFF button will illuminate.
  • If you press the ISG OFF button again, the system will be activated and the light on the ISG OFF button will turn off.

ISG system malfunction ➤

Other information:

Kia Stinger (CK) 2018-2023 Owner's Manual: Rear Seat Belt Retractor

Components and components location Component Location 1. Rear seat belt retractor [LH] 2. Rear seat belt retractor [RH] Repair procedures Replacement    When installing the belt, be careful not to damage the retractor.

Kia Stinger (CK) 2018-2023 Owner's Manual: Auto Defogging Sensor (DATC only)

Description and operation Description Installed on the windshield glass, the auto defogging sensor judges and sends signal to blow out wind for defogging if moisture occurs. On receiving the signal from the sensor, the air conditioner control module restrains moisture and eliminates fog by controlling the intake actuator, A/C, auto defogging actuator, blower motor rpm, and mode actuator.

Categories

 
Copyright © 2026 www.kstinger.com 0.0097