Kia Stinger CK: Rear Suspension System / Trailing Arm

Kia Stinger (CK) 2018-2023 Service Manual / Suspension System / Rear Suspension System / Trailing Arm

Repair procedures
Removal
1.

Remove wheel nuts, wheel and tire (A) from hub.

Tightening torque:

107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94.0 lb·ft)

  

Be careful not to damage the wheel bolts when removing the wheel and tire (A).

2.

Loosen the trailing arm bolt & nut and then remove the trailing arm.

Tightening torque:

117.7 - 132.4 N·m (12.0 - 13.5 kgf·m, 86.8 - 97.6 lb·ft)

  

Up the transmission jack under the lower arm in order to remove the rear lower arm in no-load condition.

3.

Install in the reverse order of removal.

  

Install at the empty vehicle height when it is assembled.

Inspection
1.

Check the bushing for wear and deterioration.

2.

Check the trailing arm deformation.

3.

Check the all bolts.

Rear Lower Arm

Rear Stabilizer Bar

Other information:

Kia Stinger (CK) 2018-2023 Service Manual: Steering wheel

Components and components location Components 1. Steering wheel body 2. Remote control switch 3. Paddle shift 4. Lower cover 5. Wiring 6. Damper 7. Upper cover 8. Upper cover Repair procedures Removal 1. Disconnect the battery negative cable from the battery and then wait for at least 30 seconds.

Kia Stinger (CK) 2018-2023 Service Manual: Engine Control / Fuel System

Special service tools Special Service Tools Tool Name / Number Illustration Description Fuel Pressure Gauge 09353-24100 Used for measuring the pressure in fuel line Fuel Pressure Gauge Adaptor 0K353-D4100 Used for connecting between high pressure fuel pump and low pressure fuel feed tube to measure the pressure in fuel line ※SST 09353-02100 also can be used Heated Oxygen Sensor Socket Wrench 09392-1Y100 Removal and installation of the heated oxygen sensor ※ SST No.

Categories

 
Copyright © 2026 www.kstinger.com 0.0155