Kia Stinger CK: Features of your vehicle / Windshield defrosting and defogging
Contents:
WARNING - Windshield heating
Do not use the
or
position during cooling operation
in extremely humid weather. The difference between the temperature of the outside
air and the windshield could cause the outer surface of the windshield to fog up,
causing loss of visibility. In this case, set the mode selection to the
position and fan speed control to
the lower speed.
- For maximum defrosting, set the temperature control to the extreme right/hot
position and the fan speed control to the highest speed.
- If warm air to the floor is desired while defrosting or defogging, set the
mode to the floor-defrost position.
- Before driving, clear all snow and ice from the windshield, rear window,
outside rear view mirrors, and all side windows.
- Clear all snow and ice from the hood and air inlet in the cowl grill to
improve heater and defroster efficiency and to reduce the probability of fogging
up the inside of the windshield.
Automatic ventilation
The system automatically selects the outside (fresh) air position when the climate
control system operates over a certain period of time (approximately 30 minutes)
in low temperature with the recirculated air position selected.
To cancel or reset the Automatic Ventilation
When the air conditioning system is on, select Face Level
mode and while pressing the A/C button,
press the recirculated air position button five times within three seconds.
When the automatic ventilation is canceled, the indicator blinks 3 times. When
the automatic ventilation is activated, the indicator blinks 6 times.
If the battery is discharged or detached, the automatic ventilation will be reset.
Adjust the feature accordingly.
Smart ventilation
The smart ventilation system maintains pleasant/fresh air condition inside the
passenger compartment by automatically detecting/controlling the temperature and
humidity when you drive the vehicle with the climate control system in the OFF position.
When the smart ventilation system starts to operate, the message, “SMART VENTILATION
ON” appears for 5 seconds.
- The smart ventilation system stops operating, when the OFF button of the
climate control system is selected.
- The smart ventilation system stops operating, when any button of the climate
control system is selected for operation.
- The smart ventilation system may not operate, when the vehicle is driven
at low speed.
Other information:
Kia Stinger (CK) 2018-2023 Owner's Manual: Stop Lamp Switch
Components and components location
Components
1. Brake lamp switch
2. Brake pedal
Description and operation
Operation
Operation principle
of inductive non-contact switch
1.
Use the high frequency magnetic field and the induced current that are
generated by oscillation (to approved voltage) of coil in switch.
Kia Stinger (CK) 2018-2023 Owner's Manual: High Beam Assist
The High Beam Assist is a system that automatically adjusts the headlamp range
(switches between high beam and low beam) according to the brightness of other vehicles
and road conditions.
Operating condition
1.Place the light switch in the AUTO position.
2.Turn on the high beam by pushing the lever away from you. The High Beam Assist
(
) indicator will illuminate.