Kia Stinger: Automatic transmission (shift-by-wire) / Launch Control
		
		
		Launch Control Operation
	- When using Launch Control, a driver should always make sure that the engine’s 
	cooling water is warmed up and reaches a recommended temperature.
- To operate ESC Off state 2, Press and hold ESC button for more than 3 seconds 
	in Sports mode. (Status Display on Cluster Screen)
- For launching, stop the vehicle and keep the steering wheel straight.
- Footbrakes, EPB and Auto Hold must be released for smooth launching.

	- Press the brake firmly with your left foot in transmission D mode, while 
	pressing the accelerator pedal down fully with your right foot. Then, the Launch 
	Control Ready (1) will be in place.

	- To start a vehicle, with your right foot pressing the accelerator pedal 
	down fully, remove your left foot from the brake. (within 4 seconds) (Launch 
	Control Active (2) Status Display on Cluster Screen)
- If both the brakes and accelerater pedals were applied and the driver removes 
	his foot only from the accelerater pedal, Launch Control will be automatically 
	deactivated. Or, if the vehicle does not start after 4 seconds with a driver’s 
	feet on both brake and accelerate pedals, Launch Control will automatically 
	deactivated as well.
- Do not operate both brake and accelerate pedals simultaneously for longer 
	than 4 seconds.
- When re-using Launch Control, a driver should have the vehicle cool down 
	sufficiently by driving.
Limited use of Launch Control (3)

	- An warning message will pop up on the screen if the transmission fluid temperature 
	is above a certain level while using Launch Control. Also, Launch Control will 
	be automatically deactivated.
- To address the issue as above, a driver should cool down the transmission 
	fluid temperature by driving the vehicle. (Driving at a constant speed over 
	60 km/h (37 mph) is highly recommended, but this should only be done if traffic 
	and road conditions permit the driver to do so safely.)
WARNING
It is the responsibility of the driver to make sure it is safe before using 
Launch Control. Do not use Launch Control on public roads or when pedestrian congestion 
is present. Doing so could result in an accident that causes serious injuries.
✽ NOTICE
Launch performance can vary depending on fuel, environment, tire, and loading 
conditions.
CAUTION
Constant use of Launch Control can put enormous stress on transmission, engine, 
and drive shafts and can result in vehicle damage. It is highly recommended that 
Launch Control is used after completion of the vehicle brake-in process.
   
	Never move the shift lever from P (Park) or N (Neutral) to any other position 
	with the accelerator pedal depressed.
	Never move the shift lever into P (Park) when the vehicle is in motion. 
	B ...
   
 
   When certain conditions are met, the engine is automatically decoupled from the 
transmission while the shift lever is remained in D (Drive). In this ECO Coasting 
mode, the engine stays at idling s ...
   
 
   Other information:
   
1. Turn the ignition switch and all other switches off.
2. Open the fuse panel cover.
If the switch is located in the “OFF” position, a caution indicator will be displayed 
in the cluster.
3. Pull the suspected fuse straight out. Use the removal tool provided on the 
engine compartment  ...
   
   Specifications
	
		Lubricant
	
	
		
		Item 
		
		
		Defined lubricant 
		
		
		Capacity 
		
	
	
		
		Transfer oil 
		
		
		Exclusive oil for transfer case 
		ATF SHELL TF0870B 
		
		
		0.820L 
		(0.217 U.S gal., 0.87 U.S.qt., 0.72 Imp.qt.) 
		
	
Repair procedu ...