Kia Stinger: Front Door / Front Door Belt Outside Weatherstrip

Kia Stinger CK 2018-2024 Service Manual / Body (Interior and Exterior) / Front Door / Front Door Belt Outside Weatherstrip

Repair procedures

Replacement

Put on gloves to protect your hands.

•	When prying with a flat-tip screwdriver or using a prying trim tool, wrap protective tap around the tool and related parts to prevent damage.

•	Be careful not to scratch the door trim and other parts.

1.	Pull down front door window glass by pressing the power window glass switch.

2.	Remove the front door trim. (Refer to Front Door - "Front Door Trim")

3.	Remove the front door frame inner cover (A) by using a remover.

4.	Remove the front door quadrant inner cover (B) after loosening the mounting screws (A).

5.	Remove the front door belt inside weatherstrip (A).

Install in the reverse order of removal.

•	Make sure the connector is connected properly.

•	Make sure the door locks/unlocks and opens/closes properly.

•	Replace any damaged clips.

Front Door Outside Handle

Components and components location Component Location 1. Front door outside handle Repair procedures Replacement ...

Front Door Belt Inside Weatherstrip

Repair procedures Replacement Put on gloves to protect your hands. &nbs ...

Other information:

Kia Stinger CK 2018-2024 Service Manual: SRS Control Module (SRSCM)

Description and operation Description The primary purpose of the SRSCM (Supplemental Restraints System Control Module) is to discriminate between an event that warrants restraint system deployment and an event that does not. The SRSCM must decide whether to deploy the restraint sys ...

Kia Stinger CK 2018-2024 Service Manual: Fuel Filter (For Diesel engine only)

Repair procedures Removal 1. Switch "OFF" the ignition and disconnect the negative (-) battery terminal. 2. Remove the engine cover (A). 3. Disconnect the water sensor connector & fuel heater connector ...