Kia Stinger CK: Driver Attention Warning (DAW) / System setting and activation

Contents:

System setting

  • The Driver Attention Warning system is set in the OFF position when your vehicle is first delivered to you from the factory.
  • To turn ON the Driver Attention Warning system, turn on the engine, and then select 'User Settings → Assist → Driver Attention Warning → Normal/Early' on the LCD display.
  • The driver can select the Driver Attention Warning system mode.
    - Off : The Driver Attention Warning system is deactivated.
    - Normal : The Driver Attention Warning system alerts the driver of his/her fatigue level or inattentive driving practices.
    - Early : The Driver Attention Warning system alerts the driver of his/her fatigue level or inattentive driving practices faster than Normal mode.
  • The set-up of the Driver Attention Warning system will be maintained when the engine is re-started.

Display of the driver's attention level

  • The driver can monitor their driving conditions on the LCD display.
    - Select 'User Settings Mode' and then 'Assist' on the LCD display. (For more information, refer to "LCD Display" in chapter 4.)
  • The driver's attention level is displayed on the scale of 1 to 5. The lower the number is, the more inattentive the driver is.
  • The number decreases when the driver does not take a break for a certain period of time.
  • The number increases when the driver attentively drives for a certain period of time.
  • When the driver turns on the system while driving, it displays 'Last Break time'.

Take a break

  • The "Consider taking a break" message appears on the LCD display and a warning sounds to suggest that the driver take a break when the driver's attention level is below 1.
  • The Driver Attention Warning system will not suggest a break when the total driving time is shorter than 10 minutes.

Other information:

Kia Stinger (CK) 2018-2023 Owner's Manual: General Service Information

General information Identification Number Locations Protection of the Vehicle Always be sure to cover fenders, seats, and floor areas before servicing.    Insert the supportive rod into the hole at the edge of the hood whenever inspecting the engine compartment to prevent the hood from falling and causing possible injury.

Kia Stinger (CK) 2018-2023 Owner's Manual: Oil Seal

Repair procedures Replacement Oil Seal (Main Shaft) 1. Remove the transfer case assembly. (Refer to 4 Wheel Drive (AWD) System -"Transfer Case Assembly") 2. Remove the oil seal (A) using a flat head driver.    • To prevent from oil leak at the Bentle Valve (B), replace the oil seal with the same installation direction of transfer case oil seal.

Categories

 
Copyright © 2026 www.kstinger.com 0.0086