Kia Stinger CK: Rear Seat / Rear Back Armrest

Components and components location
Component Location

1. Rear seat armrest


Repair procedures
Replacement
  

Put on gloves to protect your hands.

  
•

Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•

Take care not to bend or scratch the trim and panels.

1.

Remove the rear back armrest (C) after removing the cap(A) and then loosening the bolt (B).

2.

Remove the rear seat armrest back board (A).

3.

Install in the reverse order of removal.

  

Replace any damage clips.

Other information:

Kia Stinger (CK) 2018-2023 Service Manual: Fuel Delivery System

Components and components location Components Location Fuel Tank & Filler-Neck Assembly 1. Fuel Tank 2. Low Pressure Fuel Pump 3. Sub Fuel Sender 4. Fuel Filler Hose 5. Leveling Hose 6. Ventilation Hose 7. Filler-Neck Assembly 8. Fuel Pump Plate Cover Low Pressure Fuel Pump 1.

Kia Stinger (CK) 2018-2023 Service Manual: Engine oil

Checking the engine oil level ■ THETA II 2.0L T-GDI Engine (Gasoline) ■ Lambda II PE 3.3L T-GDI Engine (Gasoline) 1. Be sure the vehicle is on level ground. 2. Start the engine and allow it to reach normal operating temperature. 3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil to return to the oil pan.

Categories

 
Copyright © 2026 www.kstinger.com 0.01