Kia Stinger CK: Engine Mechanical System / Cylinder Block

Kia Stinger (CK) 2018-2023 Service Manual / Engine Mechanical System / Cylinder Block

Contents:

Components and components location

Components

1. Piston ring (#1)
2. Piston ring (#2)
3. Oil ring
4. Snap ring
5. Piston pin
6. Piston
7. Connecting rod

8. Connecting rod upper bearing
9. Cylinder block
10. Connecting rod lower bearing
11. Connecting rod bearing cap
12. Ladder frame
13. Oil filter bracket
14. Oil filter bracket gasket
15. Rear oil seal

1. Cylinder block
2. Piston cooling oil jet
3. Crankshaft upper bearing
4. Crankshaft

5. Crankshaft lower bearing
6. Thrust bearing
7. Crankshaft position sensor (CKPS) wheel
8. Main bearing cap

Water Jacket Separator

Repair procedures

Removal and Installation

1.	Remove the cylinder head. (Refer to Cylinder Head Assembly - "Cylinder Head")

2.	Remove the water jacket separator (A).

3.	Install the other parts in the reverse order of removal.

Drive Plate ➤

Rear Oil Seal ➤

Piston and Connecting Rod ➤

Crankshaft ➤

Cylinder Block ➤

Water pump

Drive Plate

Other information:

Kia Stinger (CK) 2018-2023 Service Manual: Smart Cruise Control (Stop & Go) System

General safety information and caution General Safety Information and Caution Be careful when driving the vehicle using the smart cruise control system as follows. • The smart cruise control system may be restricted to detect distance to the vehicle ahead due to road and traffic conditions.

Kia Stinger (CK) 2018-2023 Service Manual: Front Oil Seal

Repair procedures Replacement 1. Remove the crankshaft damper pulley. (Refer to Drive Belt System - "Crankshaft Damper Pulley") 2. Remove the front oil seal (A). 3. Install the new front oil seal. (1) Apply engine oil on the edge of new front oil seal.