Kia Stinger CK: Crash Pad / Crash Pad Center Panel

Components and components location
Component Location

1. Crash pad passenger side panel

Repair procedures
Replacement
  

Put on gloves to protect your hands.

  
•

Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•

Take care not to bend or scratch the trim and panels.

1.

Remove the crash pad side cover [RH] (A) by using a remover.

2.

Remove the crash pad garnish [RH] (A) after loosening the mounting screws.

3.

Separate the crash pad passenger side panel (A) after loosening the mounting screws.

4.

Disconnect the start/stop button connector (A) and then remove the crash pad garnish.

5.

Install in the reverse order of removal.

  
•

Make sure the connector are connected in properly.

•

Replace any damaged clips.

Other information:

Kia Stinger (CK) 2018-2023 Service Manual: Hood Garnish

Repair procedures Replacement    Put on gloves to protect your hands.    • Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

Kia Stinger (CK) 2018-2023 Service Manual: Oil Pan

Repair procedures Removal 1. Remove the engine room front under cover and side cover. (Refer to Engine and Transmission Assembly - "Engine Room Under Cover") 2. Drain the engine oil. (Refer to Lubrication System - "Engine Oil") 3. Remove the engine mounting support bracket nut (A).

Categories

 
Copyright © 2026 www.kstinger.com 0.0097