Kia Stinger CK: Front Suspension System / Front Stabilizer Bar

Kia Stinger (CK) 2018-2023 Service Manual / Suspension System / Front Suspension System / Front Stabilizer Bar

Repair procedures

Removal

Remove wheel nuts, front wheel and tire (A) from hub.

Tightening torque:

107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94.0 lb·ft)

Be careful not to damage the wheel bolts when removing the wheel and tire (A).

Loosen the nut and then separate the stabilizer link from the front shock absorber.

Tightening torque:

98.1 - 117.7 N·m (10.0 - 12.0 kgf·m, 72.3 - 86.8 lb·ft)

Loosen the bolts (A) and then remove the stabilizer bar.

Tightening torque:

49.0 - 63.7 N·m (5.0 - 6.5 kgf·m, 36.2 - 47.0 lb·ft)

4.	Install in the reverse order of removal.

Inspection

1.	Check the bushing for wear and deterioration.

2.	Check the front stabilizer bar for deformation.

3.	Check the front stabilizer link ball joint for damage.

Other information:

Kia Stinger (CK) 2018-2023 Service Manual: Oil Level Gauge & Pipe

Repair procedures Removal and Installation 1. Remove the oil level gauge (A). 2. Remove the engine room front under cover and LH side cover. (Refer to Engine and Transmission Assembly - "Engine Room Under Cover") 3. Remove the LH engine mounting support bracket nut (A).

Kia Stinger (CK) 2018-2023 Service Manual: TPMS Receiver

Description and operation Operation 1. General Function • Auto-learn takes place only once per Ignition cycle. • On successful completion, 4 road wheel sensor ID's are latched into memory for monitoring. • Until Auto-learn completes, previously learned sensors are monitored for under inflation / leak warnings.

Kia Stinger CK: Front Suspension System / Front Stabilizer Bar

Repair procedures

Front Lower Arm

Sub Frame

Other information:

Categories