Kia Stinger: Rear Door / Rear Door Window Glass

Kia Stinger CK 2018-2025 Service Manual / Front Seat Belt / Rear Door / Rear Door Window Glass

Components and components location
Component Location

1. Rear door window glass


Repair procedures
Replacement
  

Put on gloves to protect your hands.

  

Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

Take care not to bend or scratch the trim and panels.

1.

Remove the rear door trim.

(Refer to Rear Door - "Rear Door Trim")

2.

Remove the rear door frame inner cover (A) by using a remover.

3.

Remove the rear door belt inside weatherstrip (A).

4.

Remove the rear door belt outside weatherstrip (A) by using a remover.

5.

Remove the rear door drive channel (A) after loosening the mounting screws.

6.

Remove the rear door frame molding (A) by using a remover.

7.

Remove the rear door frame garnish (A) and glass run.

8.

Remove the rear door window glass mounting hole plug (A).

9.

Loosen the mounting bolt, and pull out the rear door window glass (B) by tilting it sideways.

Tightening torque :

7.8 - 11.8 N·m (0.8 - 1.2 kgf·m, 5.8 - 8.7 lb·ft)

  

Be careful not to drop the glass and/or scratch the glass surface.

  

Use the door switch to align the mounting hole/bolt with the hole in the door.

If the window motor cannot be operated, remove the motor and align the hole by hand.

10.

Install in the reverse order of removal.

  

Roll the glass up and down to see if it moves freely without binding.

Adjust glass position as needed.

Make sure that the door locks and opens properly.

Replace any damaged clips.

Rear Door Inside Handle
Repair procedures Replacement 1. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 2. Rremove the rear door inside h ...

Rear Door Module
Components and components location Component Location 1. Rear door module Repair procedures Replacement   ...

Other information:

Kia Stinger CK 2018-2025 Owners Manual: Windshield wipers


Operates as follows when the ignition switch is turned ON. MIST : For a single wiping cycle, move the lever to this (MIST) position and release it. The wipers will operate continuously if the lever is held in this position. OFF : Wiper is not in operation INT : Wiper operates intermittently at ...

Kia Stinger CK 2018-2025 Owners Manual: Wiper blades


Blade inspection Commercial hot waxes applied by automatic car washes have been known to make the windshield difficult to clean. Contamination of either the windshield or the wiper blades with foreign matter can reduce the effectiveness of the windshield wipers. Common sources of contaminati ...

Copyright © www.kstinger.com 2015-2025