Kia Stinger: Hood / Hood Latch

Kia Stinger CK 2018-2025 Service Manual / Front Seat Belt / Hood / Hood Latch

Components and components location

Component Location

1. Hood latch assembly

Repair procedures

Replacement

1.	Remove the front bumper. (Refer to Front bumper - "Front bumper Assembly")

2.	Remove the hood latch assembly (A) after loosening the mounting screw.

3.	Disconnect the hood latch cable (A).

4.	Disconnect the hood latch connector (A) after loosening the mounting screw.

Install in the reverse order of removal.

•	Make sure that the hood latch release cable is connected properly.

•	Make sure that the hood locks/unlocks and opens/closes properly.

•	Adjust the latch alignment.

Hood Latch Release Handle

Components and components location Component Location 1. Hood latch release handle Repair procedures Replacement 1. Afte ...

Interior Trim

Components and components location Components 1. Front pillar trim 2. Center pillar upper trim 3. Rear pillar trim 4. Cowl side trim 5. Front door scuff trim ...

Other information:

Kia Stinger CK 2018-2025 Service Manual: Mechanism Rail

Components and components location Components Location 1. Mechanism Rail Repair procedures Replacement Put on gloves to protect your hands. ...

Kia Stinger CK 2018-2025 Owners Manual: Windshield wipers

Operates as follows when the ignition switch is turned ON. MIST : For a single wiping cycle, move the lever to this (MIST) position and release it. The wipers will operate continuously if the lever is held in this position. OFF : Wiper is not in operation INT : Wiper operates intermittently at ...