Kia Stinger CK: Maintenance / Chassis
Contents:
- Brake/Clutch Fluid
- Disc Brakes and Pads
- Drive Shafts and Boots
- Parking Brake
- Steering Gear Rack, Linkage and Boots
- Suspension Ball Joints
- Suspension Mounting Bolts
- Tire (pressure & tread wear)
Brake/Clutch Fluid
Repair procedures
| Inspection |
Check the brake fluid level in the brake fluid reservoir. The level should be between “MIN” and “MAX” marks on the side of the reservoir.
Use only hydraulic brake fluid conforming to DOT 3 or DOT 4 specification.
Check the brake system for any leakage if the fluid level is extremely low (lower than MIN).
Disc Brakes and Pads ➤
Drive Shafts and Boots
Repair procedures
| Inspection |
| 1. |
Check the drive shaft boots for loose clamps, cracks, grease leaks, kinks or damage.
|
Parking Brake
Repair procedures
| Inspection |
Check whether the stroke is within specification when the parking brake pedal is depressed with 66 lb, 294 N(30 kg) of force. Also, the parking brake alone should securely hold the vehicle on a fairly steep grade. If the stroke is more or less than specified, have the parking brake adjusted by an authorized Kia dealer.
|
Stroke : 6 - 7 notch |
Steering Gear Rack, Linkage and Boots ➤
Suspension Ball Joints
Repair procedures
| Inspection |
Visually check to be sure that there are no flaws and cracks that may cause injury.
Suspension Mounting Bolts
Repair procedures
| Inspection |
Visually check for loose mounting bolts.
Tire (pressure & tread wear) ➤
Other information:
Kia Stinger (CK) 2018-2023 Service Manual: Seat belt switch
Description and operation Description Via the seat belt/door switch, the ISG function can detect if the driver side seat belt is fastened and the driver side door is closed. If the driver side seat belt/door are not fastened/closed, the ISG system will not operate. If the seat belt/door are unfastened/opened, the engine will not start or stop by the ISG function for safety reasons.Kia Stinger (CK) 2018-2023 Service Manual: Steering Gear box
Components and components location Components 1. Tie rod end 2. R-MDPS motor Repair procedures Removal 1. Remove wheel nuts, front wheel and tire (A) from hub. Tightening torque : 107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94.0 lb·ft) Be careful not to damage the wheel bolts when removing the wheel and tire (A).Categories
- Manuals Home
- Kia Stinger Owners Manual
- Kia Stinger Service Manual
- Brake/Clutch Fluid
- Disc Brakes and Pads
- Drive Shafts and Boots
- Parking Brake
- Steering Gear Rack, Linkage and Boots
- Suspension Ball Joints
- Suspension Mounting Bolts
- Tire (pressure & tread wear)
- New on site
- Most important about car
Contents
