Contents:
| Components |

| 1. Sub frame assembly 2. Front fixed panel assembly 3. Wind deflector assembly 4. Roof side molding |
5. Roller cassette assembly
6. Mechanism rail assembly 7. Glass motor 8. Roller blind motor |
| Adjustment |
Inspect Glass Alignment
| 1. |
Inspect the alignment of the moving glass (C) between the front glass (A) and roof panel (B) and adjust it if needed.
|
| 2. |
Tilt the moving glass by using the wide sunroof switch.
|
| 3. |
Remove the both sides mechanism cover (A).
|
| 4. |
Adjust the height of the glass by slighty loosening the screws (A).
|
| 5. |
Completely close the moving glass using the wide sunroof switch. |
| 6. |
Install the mounting screws (A) after adjust the height of the glass. |
Emergency operation
| 1. |
Use the wide sunroof emergency operation only when the sunroof needs to be opened or closed in case of engine failure. |
| 2. |
Use a hexagon wrench to open or close the wide sunroof after removing the roof trim. Do not apply too much force when opening or closing the wide sunroof. [moving glass motor ]
[roller blind motor]
|
| 3. |
If needed, reset the wide sunroof according to the reset method. (Refer to Body Electrical System - "Wide Sunroof Motor") |
| Replacement |
| 1. |
Completely open the moving glass using the wide sunroof switch. |
| 2. |
Remove the wide sunroof deflector (A) after loosening the mounting screws located on the front.
|
| 3. |
Install in the reverse order of removal. |
Kia Stinger (CK) 2018-2023 Service Manual: Driver's and passenger's front air bag
■ Driver’s front air bag ■ Driver’s knee air bag ■ Passenger’s front air bag Your vehicle is equipped with an Advanced Supplemental Restraint (Air Bag) System and lap/shoulder belts at both the driver and passenger seating position. The indication of the system's presence are the letters “AIR BAG” located on the air bag pad cover on the steering wheel and the passenger's side front panel pad above the glove box.Components and components location Components 1. Piston ring (#1) 2. Piston ring (#2) 3. Oil ring 4. Snap ring 5. Piston pin 6. Piston 7. Connecting rod 8. Connecting rod upper bearing 9. Cylinder block 10. Connecting rod lower bearing 11. Connecting rod bearing cap 12. Ladder frame 13.